Products       Principal profile         Product Catalog   
     Consultants Approval         Clients

EEL high capacity belt bucket elevators for greater fitting eights are equipped with steel cable reinforced belts especially designed for this application. The belt ends are fastened with a special clamping device. In case conveyed material temperature is high, special high temperature resistant rubber mixtures are used as belt materials. An automatic tensioning device developed by EEL ensures correct belt tension under a variety of operating conditions, prevents slack belt operation and reduces the resultant wear of the return pulley. The boot pulley is a cage type with material deflection cones. The mounting segment for the buckets is a EEL development. A creep drive is used for maintenance and inspections. A hydraulic fluid coupling between the main drive motor and the gear box ensures smooth start-ups and acts as an overload protection. Material level indicator, motion detector and belt-sway switches are standard controls and safety devices. The bucket elevators have self supporting single or double casings, made of sheet metal and feature large maintenance and erection doors.

Important advantages of belt bucket elevators over chain bucket elevators are :

• lower wear and tear
• quite operation
• higher specific conveying capacity
• lower power consumption
• most suitable for handling cement, raw meal coal etc.

INCHING DEVICE
This is normally a low speed geared motor. It permits low speed drive for inching and turning of large size and high speed bucket elevators in case of maintenance, inspection and test run

NI-HARD BEARING
This type of Bearing along with housing are specially designed for Boot Shaft in  Nickle-Chrome material. Advantages as better alignment of shaft, non lubricated, less wear & tear, easy to dismantle and above all longer working life.

COUNTER-WEIGHT TYPE TAKE-UP
In addition to Screw Type, the counter-weight type take-up is another selection of take-up units. This take-up provides automatic tensioning and is suitable and popular when lumpy materials are elevated.

BELT MISALIGNMENT SWITCHES
These switches are used for monitoring the true tracking of Elevator Belt in order to avoid damage. The switches will operate if the belts exceeds the permissible deviation from the nominal tracking.